UPCOMING PHASE TEST!

Here is the schedule:

4th May- Electrical Technology

6th May- General Engineering Knowledge

8th May- Naval Architecture

9th May- Mechanical Science

11th May- Workshop theory

13th May- Industrial Gas Turbine

18th May- Mathematics

20th May- Ugama

Well..wish me luck!

Workshop Theory & Engineering Drawing Assignment

I had completed the three pending assignments today!

Workshop Lesson ( Dis ambling Compressor)

Last two workshop lessons, we were doing the dis ambling of refrigerant compressor. I had problem updating about this last time due to piling of assignment to be done as well as doing the revisions for this  upcoming Phase Test 3 which will be held on this Saturday..So here are the activity during the workshop lesson:

Here is how refrigerant compressor looks like

As usual, the compressor is wrapped with sling wire 

and lifted by hydraulic jack

the motor casing was removed

as the piston casing was removed, the piston could be seen

the crane shaft's casing was removed and the shaft was tested

Last workshop lesson, we were doing the dis ambling of engine but it was not completed so i will update them next week, Insya-Allah..Below is the picture of the engine

MIB School trip!

A fascinating and fun school trip was held today. My course-mates were brought to The Royal Regalia Of Brunei Darussalam and to Galeri Bubungan Dua Belas..The royal regalia are displaying the events during the early times of Brunei Darussalam, the treaties made,the carnations of our Sultan and all the equipment and clothing used during the time. Galeri Bubungan Dua Belas is where the royal families were once stayed and it is called Bubungan dua belas is because it has twelve roofs. So below are some pictures taken today

The Royal Regalia

We were asked to take off our shoes and wear that slipper 

The model of Royal Brunei Airplane

Our two instructors in charge on the trip

Some tourists were there too

Next is the Bumbungan Dua Belas: